Where should closet rods be placed?

As a rule, place the top rod 80 to 82-inches up from the floor and the bottom rod about 40-inches up from the floor. For a single rod application, plan 60-inches from the floor for placement. You will need at least 1-foot, 9-inches (24-inches is standard) away from the back wall for hanging.

Can you hang a closet rod in drywall?

Can You Hang a Closet Rod in Drywall? You can hang a closet rod in the drywall in such a fashion that it holds your clothing without pulling out of the wall. In order to do so, it’s best to use shelf support style brackets. These brackets can be set at any point along the back wall of your closet.

How far should closet rod be from shelf?

Leave wiggle room between closet rods and shelves.

If this is the case, mount the closet rod below the shelf, achieving a distance of at least two inches from the bottom of the shelf to the top of the rod. Without this clearance, the space between the shelf and rod will be too tight to maneuver hangers.

Why does my closet rod keep falling?

However, if you’ve overloaded your closet rod by squeezing too many clothes into too small a space, or if it’s simply too thin for the job, it could sag in the middle.

Do closet rods need to go into studs?

Basic Installation Instructions

It should be placed in front of a stud so you can screw into the stud to give it support. The typical height of a closet rod is from 60 to 80 inches, and both brackets should be at the same height, or the hooks you hang from the rod will slide to one end.

Are there studs in a closet?

Closet shelves are usually anchored to the wall where the mounting screws can grab wall studs. If your walls are masonry, you likely don’t have studs at all. You’ll need the proper materials and methods to build a stud-free closet shelf.

What is the strongest drywall anchor?

Traditional metal toggle bolts are the strongest of the bunch, but they’re not the simplest to install because they require drilling a hole that’s approximately three times wider than the diameter of the bolt (necessary to insert the anchor).

How much weight should a closet rod hold?

Aluminum Anodized Elite 1-5/16”: Up to 80 lbs. Stainless Steel 1-1/16”: Up to 95 lbs. Steel Polished Chrome Round 1-1/16”: Up to 110 lbs. Steel Polished Chrome Round 1-5/16”: Up to 170 lbs.

How thick should a closet rod be?

A closet-rod dowel is usually between 1 1/4 inches to 1 3/8 inches in diameter. This diameter allows for plenty of hanging strength. It resists breakage, and will not bend when properly supported.

Can a closet be 20 inches deep?

The comfortable recommended depth of a closet is 24” (61 cm), but closet depths as narrow as 20” (50.8 cm) can be used if desired. Shelf depths of 12” (30.5 cm) should be used for shoes and smaller clothing elements.