What do pool filter settings mean?

Filter. The lever should be on the ‘Filter’ setting most of the time. This is the setting that provides normal pool filtration by pushing the water through the filter media (sand, glass beads or D.E) that then traps any dirt and debris before the water is returned to the pool.

Should I run my pool pump on filter or recirculate?

You should run your pump/filter as long as it takes to keep the pool clean. Some pools have great circulation combined with low use, therefore run times can be quite short. Other pools have lousy circ systems and huge bather loads and even 24/7 filtration has trouble keeping up.

What is the waste position on a pool filter?

The WASTE Position:

Waste diverts the water pumped in from your pool from the filter and sends it directly out of the backwash hose, without even entering the filter tank. It’s one of two ‘Bypass’ settings on a multiport valve.

Should I run my filter when I shock my pool?

Running your filter after shocking your pool is a must and is just as important to your pool as shocking it is. Be sure to run your filter for at least 6 hours, but shoot for 24 hours to several days, if your pool is particularly dirty or has algae, to properly circulate the chlorine and clean the water.

How long should you rinse a pool filter?

Rinse the filter for about 1 to 2 minutes or until the water in the sight glass is clear. NOTE: Any electric heater must be off. Stop the pump. Turn the lever to RINSE, start the pump and rinse for about 15-30 seconds.

What is the difference between waste and backwash?

Drain/Waste: Opting the drain or waste setting will remove pool water without forcing it through the filter. Backwash: This clears out any debris, dirt and other contaminants that may have accumulated on the filter. Closed: if you choose this setting, then the flow of water to the pool and filter will be stopped.

Do I need to rinse after backwash?

In order to prevent residual blow back into the pool, once you’ve finished backwashing it’s highly advisable to rinse the filter. Just as the backwash lifts and flushes the sand, the rinse resets the sand to its original position for optimum filtration.

How often should you backwash a pool?

Bottom line, the filter must be backwashed on a regular basis to ensure that your pool water is clear. “When do we need to backwash?” – It is recommended to backwash your filter once every 4-6 weeks of regular use.

Do you vacuum a pool on backwash or waste?

If you do have this option, it is highly recommended that whenever you have algae, you will need to vacuum to waste. This option allows you to vacuum the algae up and send it out through the backwash line, avoiding getting algae into your filter sand.

What is the recirculate position on a pool pump?

The recirculate setting on a swimming pool filter is actually used to bypass the filter mechanism. Recirculate allows the water to flow out of the pool and back into it again without running through the sand or diatomaceous earth in the filtration system.

Why did my pool turn green after I shocked it?

Pools can immediately turn green after shocking when they have metals like copper or iron in the water. These metals oxidize when exposed to high levels of chlorine which makes the pool water turn green. Metals in the water are caused by some algaecides and using well water.

Should I brush pool before shocking?

Before you start pouring shock in the pool, the first step is to brush the sides and floor of your pool to loosen all the algae. Doing this breaks the skin and allows the pool shock to more easily kill the algae. Once you’ve done this, it is important to make sure you have the proper pH level in your water.

Can you swim in pool after you shock it?

After Shocking Your Pool

It is safe to swim once your chlorine levels are around 5 ppm or after 24 hours. It is always best to test first!