The serv TPM means “Service Tire Pressure Monitor system” The first thing that will need to be done is to have the module relearn the TPM wheel sensors. The vehicle may be confused as to the correct location of each tire pressure sensor. Whenever the tires are rotated this procedure has to be performed.

What is TPM on my vehicle?

The purpose of the TPMS (Tire Pressure Monitoring System) is to alert you when tire pressure is too low and could create unsafe driving conditions. If the light is illuminated, it means your tires could be underinflated, which can lead to undue tire wear and possible tire failure.

What does service TPM mean on a 2007 Chevy Colorado?

SERV TPM= Service Tire Pressure Monitor. It means there is a malfunction in the system. Usually one of the wheel sensors is not communicating with the BCM. This message will also show if the tires were rotated and the “sensor relearn” was not accomplished.

How do you reset the SERV TPM on a Chevy Colorado?

You must screw the valve stem cap back onto the end of the valve stem to reset the chevy colorado tpms. Switch the ignition key to the “on,” or second, location on the ignition but don’t crank the engine. Press and hold the reset button on the instrument panel before blinking begins with the tpms light and then exits.

Why TPMS light on but tires are fine?

When the air pressure in your tires falls below the proper temperature, an indicator light will flash in your dashboard. However, there are a number of situations in which the TPMS light may be on but your tires don’t need to be changed or maintained. When this happens and all of your tires appear normal.

Can I drive my car with the TPMS light on?

It’s not safe to drive around with your TPMS light illuminated. If the light comes on while you’re driving, slow down and get to the nearest gas or service station to inspect the tire.

At what PSI will the TPMS trigger a warning for this car?

Tire pressure monitoring systems (TPMS) warn the driver when the tire pressure of the vehicle is 27% below the target pressure. Suppose the target tire pressure of a certain car is 31 psi. A. Pressure +31(27% of 31)= When tire pressure is below 22.63, the TPMS triggers a warning for the car.

What should my tire pressure be?

Proper tire pressure can vary from vehicle to vehicle, but for most makes and models the recommended tire pressure is between 30-35 PSI (pounds per square inch). Avoid over-inflating your tires to max pressure or beyond in order to prevent poor braking and decreased tire life.

Where is TPMS sensor located?

Where is the tire pressure sensor located? It is inside the tire attached to the inner part of the rim. If you remove the tire from the rim, you’ll see a small cylinder, which is the tire pressure sensor.

How do you reset the TPM on a 2007 Chevy Colorado?

2007-2010 Models
Turn the ignition key to the “ON” position without starting the engine. Turn the exterior lamp switch from AUTO to OFF 4 times within 3 seconds. Activate the TPMS sensor. Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire.

What PSI should Holden Colorado be?

This tyre placard recommends a minimum tyre pressure of 35psi for the Holden Colorado. This is equal to 240kPa and 2.4bar.

What is a TPMS relearn tool?

Relearning. Relearning tools are used to locate new sensors. The Engine Control Unit (ECU) needs to know the location of the sensors if you have new ones installed or if you’ve installed new tires. Relearning tools also activate the sensors if they are in sleep mode.